Forced Induction

488 topics in this forum

1. Garrett GT2860RS vs Holset HY35

   By TiZiK, February 21, 2023
   • 19 replies
   • 983 views
   • 
   • TiZiK
   • March 25, 2023

2. turbo oil pump

   By Bobby, September 26, 2019
   • 6 replies
   • 980 views
   • 
   • Bobby
   • September 27, 2019

3. EFI..........

   By davecara, October 1, 2018
   • 4 replies
   • 977 views
   • 
   • davecara
   • October 1, 2018

4. Oil leak 1 2

   By Reinhoud, October 25, 2022
   • 28 replies
   • 977 views
   • 
   • Maggotbreath
   • December 13, 2022

5. FORCED INDUCTION POWER

   By slabbyfaceddean, June 3, 2019
   • 1 reply
   • 975 views
   • 
   • Captain Chaos
   • June 3, 2019

6. Show us your boost gauges

   By Wee Man, December 22, 2017
   • 4 replies
   • 973 views
   • 
   • Scara
   • February 24, 2018

7. Intercooler thoughts

   By Mark, September 14, 2019
   • 7 replies
   • 971 views
   • 
   • Captain Chaos
   • September 16, 2019

8. Advice on turbo setup

   By Builder45, August 25, 2022
   • 19 replies
   • 959 views
   • 
   • Duckndive
   • August 30, 2022

9. GSXR750 Clutch Cover on 11/12

   By slingy1157, July 31, 2015
   • 0 replies
   • 955 views
   • 
   • slingy1157
   • July 31, 2015

10. Fast from the past

    By cnap504, February 25, 2022
    • 4 replies
    • 953 views
    • 
    • cnap504
    • Saturday at 10:47 PM

11. Oil out of bov

    By Jdeac, June 14, 2022
    • 12 replies
    • 949 views
    • 
    • Gixer1460
    • July 24, 2022

12. Innovate LC-1 AFR Gauge Question

    By skelly, December 20, 2018
    • 4 replies
    • 942 views
    • 
    • Gixer1460
    • December 23, 2018

13. draw through lurbication...

    By mr jason, February 15, 2016
    • 2 replies
    • 933 views
    • 
    • mr jason
    • February 15, 2016

14. Plenum Take Off Pipes

    By mick-ne, March 7, 2019
    • 4 replies
    • 919 views
    • 
    • mick-ne
    • March 9, 2019

15. had a bit of a dyno session

    By MeanBean49, April 11, 2016
    • 4 replies
    • 915 views
    • 
    • MeanBean49
    • April 12, 2016

16. Running clearance

    By davecara, March 5, 2018
    • 6 replies
    • 914 views
    • 
    • davecara
    • March 11, 2018

17. Clutch slipping?

    By Reinhoud, August 30, 2020
    • 9 replies
    • 907 views
    • 
    • Reinhoud
    • October 24, 2020

18. Compressor map

    By Chadillac, March 2, 2019
    • 5 replies
    • 904 views
    • 
    • Chadillac
    • March 2, 2019

19. Turbo fuel pipe ??

    By Mike750, August 6, 2019
    • 6 replies
    • 895 views
    • 
    • Mike750
    • August 8, 2019

20. Go easy, two spare frames and a turbo itch

    By Swirl, May 29, 2017
    • 4 replies
    • 893 views
    • 
    • Bigkenxx
    • June 2, 2017

21. B12 turbo 1216cc oil wet inlet valves

    By Fula28, May 31, 2019
    • 4 replies
    • 891 views
    • 
    • Gixer1460
    • May 31, 2019

22. Turbo oil drain

    By rerb, March 1, 2021
    • 9 replies
    • 891 views
    • 
    • clivegto
    • March 6, 2021

23. Recommendation for fitting Hayabusa Pistons in to a B12

    By Brians 7/12, June 11, 2020
    • 3 replies
    • 889 views
    • 
    • Hoomietune
    • August 16, 2020

24. Will this work on my engine withouot choking?

    By gixxerturbo, November 20, 2015
    • 2 replies
    • 878 views
    • 
    • banoffee
    • November 20, 2015

25. B12 turbo mk2 oil cooler options

    By Fula28, March 13, 2018
    • 2 replies
    • 878 views
    • 
    • MeanBean49
    • March 14, 2018