wraith

Cheers, is the KOC site back up and running now?

Dose anybody know if the kat 650 seat cover fit the kat 550 seat? I have been told the side panels and tank are bigger on the 650, so is the seat? Cheers.

Was that in Streetfighters years back ?

Dose anybody know it a gsxr ignition switch will fit on a b12 yoke? Reason is I have gsxr harness and b12 yokes, and I know the b12 has 6 wires and the gsxr has 4 or can I leave out 2 of the wires on the b12 switch and so which? Thanks.

Hi and welcome to OSS. The gsxr motor will rev to about 10,500 rpm in stead of the b12 9,500 rpm. Car't remember what the standard teeth on the b12 is ? If the 47t is much bigger you may need a longer chain or cut it down if the other way.

4th pic down, I think you may need more ground clearance

Cheers, it gives me some more to go on if I can't find a et frame. Cheers

Cheers all How's the b12 bud?

I remember in the past see gs1000 with gsx et bodywork on them. Has anybody on here done this and how did it go? Or have you any pics ? Cheers

Welcome to OSS, hope you can get a new job to help with the project, which looks like you have there.

That looks very nice

Welcome, pics are always good

Cool Cheers all the good news bits are coming togever for next project

Yes there was and I did have a copy on the old computer till it crashed, also had forks,wheels etc. So its out there.

Cheers

Long story, but the next project I'm going to do will have a b12 motor, but swooping the 38mm carbs off the kat and putting them the b12 and the b12 carbs on the kat, as the b12 motor will be more tuned. I degrees, will be using a b12 harness with mk1 motor the question is which cdi black box will work? Do I have to get a mk1 one or will say one of the latter k models work? Thanks

Nice one, thanks.

Got a set of b12 mk1 bst carbs, but they have not got the black electoral plug on the side of number 4 carbs, just a bar sticking out. So will the carbs still work on a non bandit motor? Or do I need to get one, even that it will not be coneted? Thanks.

Welcome in

Cheers Has the 750 a 17mm swing arm spindle or is that the 1100?

If you don't have the vacuum pipe on that's why it will not run, smaller pipe from tape runs usual to number 2 carbs, but someone will be along with a pic to show you better than I can say in words

OK, this may of been asked before but cannot find anything, so sorry. What if any are the difference between the gsx750et frame and the gsx1100et frame? Swingarm spindle etc? Cheers

Nice

Dose not help in some ways, but do some don't. The one on my GS dose not have a oil ring and is fine and has plenty of oil pressure but I do have the gsx750et oil pump gears in my motor.

If gsx power screen they are still a soft can best with gsxr cams