clivegto

What make are they ? I usually use Torques UK and on occasion Chinese ones, never had a problem so far. However I did buy a bike last year that had been stud for 10 years and the outer bolts had split with corrosion/age.

Was called it the wheelie wire round hear its under the left side panel there's actually 2 wires. I like turbo bikes but to answer your question fit a full race exhaust system big bore high comp pistons stage 3 dynojet kit with pod filters and get the head ported this should give you up to around 150hp. Do the suspension as well it's one of the best upgrades you can do.

As said brass bush in it take steel top hat out clean all the dryed up crud re-greas it.

Search Warpspeed Racing.

Well done on been bike of the month a superb build.

Take a chill pill man then go figure it out your self with a bit of common sense then, instead of ranting

My Slabby Metmachex is fairly robust.

What does your Metmachex arm measure.

Same weekend as Melbourn.

I'm in.

https://accbilletengineering.co.za/wp-content/uploads/2019/08/DSCN8429.jpg These are nice 1100 ones.

Yes mate, looks like I have a set and a halfway of 1100 ones which are all steel and look standard to me. All my 750 ones are aluminium but think some of the slingshots have a mix.

Took a front and back Slabby 1100 mounts of my project to measure them bud. Measurements are approximate to centres. O the 1100 ones are steel and the 750 ones are aluminium.

Just a pair of bottom ones although I have some on my 1100.

Drew round some 750 ones recently for @GeorgeEI7KOit's on graph paper each big square is 10mm.

Which ones you after mate.

As said above the stainless steel Hindley systems are thin wall and about the same weight as a ti system and a excellent performance exhaust @gsxr884is a hindle dealer

Trick as though.

Wow

@gsxr884might be able to get them as he is a hel dealer, he's in the traders section as well. Or @Gsxrsammight be able to make you some it you ask nicely.

Seen a few without vin plates.

Black & Silver for me but blue & white will always sell the best as you know

B12 & B6 are 20mm

Coz there scared of you

Some one did it on the old site I seem to remember they welded infills on the bottom back of the tank for aesthetic reasons.