fatblokeonbandit

FFS Ash where do you find this stuff!!

yup 50/54 and the adapters are hayabusa ones from Eblag to take radial callipers

RSV prillia in slingshot forks, 750 not 1100 but makes no differance.

Bugger me that's shiney

It should fit but the lines are shaped differently to be routed around tne exhaust in a different orientation...

Mine has mikuni jets, not sure about the differences between gsxr and b12 36mm mikeys??? the screw's should be fine as they are a direct replacement for the standard ones..i must get some one day..

just had a thought, 144 is a dynojet size isn't it, that's equivalent to 135 mikuni I think??

ive got b12 carbs on my 1216 big bore lumpy cammed 150 rwhp and it was set up on a dyno 5 years ago and has 145 mains, IIRC, so just a pipe and filter wouldn't need so much main jet, perhaps, mabey???? do you mean long pilot screws like these??? I keep meaning to get a set.............. http://www.factorypro.com/Prod_Pages/prods09.html

Standard mains are 122.5's, with and air filter and exhaust Id go 10% up first, so around 135's.

I had a kaw***ki 125 moto-crosser front brake hose on a b12 as a clutch hose, exactly the right length plastic coated and cost £1.99. plus post on ebog

Yes. also early bandit 1200 and any 17 inch slingy fornt

Make your own its easy, been doing it for years

Sorry Ash changed my mind ill come get it tomorrow we did say a month on approval didn't we???? Looking good shipmate, looking good

ve just done it in reverse, slingshot arm into bandit, I had to chop 10mmish off either side.. spindle size is the same 20mm, what id do is get a bag of 2mm x 20mm washers and fit enough to make it all snug and then measure the pile of washers, easy peasy

Not straight in, its narrower at the pivot point, needs spacers

Yes, all slingshot 17 inchers are the same fitment as bandit 1200 mark 1 and 2 and rf900

No where near as fast but just as much fun, and who is the bloke on the GS1000?? And sorry for the poor quality i need a new camera..

They are non standard ones, I think 2 are available but the other 2 aren't... the main pivot needle rollers are 25x33x35mm which isn't a standard size, Suzuki price £34.20 each... the ones in the dog bone pivot are 17x24x25mm which is TA1725Z or HMK1725B £11 each from simply bearings...Suzuki price £23.99 each..

Take it to cadwell and give it a good thrashing

The wheel brakes and spindl3 are al, interchangeable

Its Thatchers Traditional, not sure if it safe to give to a load of northern shandy drinkers.

Picked some stuff up for YJ on the way back from Lands end and met Jason whos a nice bloke

Good job, Ash. Just had a slight feeling of regret seeing it all ready to go. But needs must and all that, enjoy it shipmate

so when I go down the M4 towards Lundun, do i turn left or right at the end?? If only I could find my satnav charger!!!