clivegto

Uuuh, nicely done.

ZXR 750 swinging arm, was thinking maybe cut the brace of and weld it to the extended slabby arm. Was surprised how heavy the arm was so fitting the hole arm & extending that is a no go.

More fafing about, trimmed a bit of the seat unit but need the rubber tank mounts to line it up properly. Needs to be a bit lower I think ?

More pics then. Got a gsxr 750k4 complete rear seat unit all I have to do is make it fit the harris with out moding the frame . Plan is to lift the seat higher as I have read that magnum 2's are quite cramped. Not quite as high as in the pic. Ordered 4 tank rubbers from harris today they dont stock the 2 needed to hold the tank on as the use't to get them from the vacume cleaner shop from round the corner, couldn't help but laugh down the phone when they told me that.

Thinking of using this extended slabby arm that was in paulm's turbo et. Forgot to mention it will be getting a gsxr 1100 or b12 lump with a turbo as well.

GSXR 1100 and GSXR 750 slabby swinging arms, I know the linkage set up is difrant but what size is the box on the 1100 and the length of the 1100 arm I have 750 arm to compare.

The arrow looks much nicer, closer to the engine & frame. Angle of the can is slightly bettor to.

Been doing the obligatory mock up when you first get a new project. I have some r1 wheels which are close to the frame colour. Think I might keep the frame colour. Just put some b12 forks in for now, pic of the first seat unit came with the frame & is heavier than the bludy tank. Second one is of my other slabby project. The r1 wheel is to big for the little gull arm.

Nice to see you again mate good luck with the op. After a 2 1/2 hour road trip to get there it took 3 1/2 hours to get home but have a smile on my face.

Pm me you address I will do it later today.

I have some out of a frame at the moment I could draw round them on some card & post it to you.

Lovely bike & nice to have a chat about it with Bondy as well at Donington.

Engine in my 750 frame is 1100f slabby engine mounts did make some of the spacers up as didn't have them all. Some pics maybe not the best to see what go's where, I just did it by trial & error. Pics front bottom back.

Yes.

Thanks but have ordered one.

Chrome Ish powder coat.

Figured it out I think b12 gsxr1100 rf900.

Am I right in thinking this is gsxr1100k.

You were right FB shortened the push rod 1mm & it now works a treat.

I thank you, thats what I was thinking but you have confirmed it.

Have now put a 1100k 100mm one in, It will engage 1st gear will not change to second & will not drive when clutch lever is released. Why ?

O dear.

Gsx 1100f

80mm on the top one is to short.