davecara

Actually on a slabby for a change! Airbox yay or nay? It’s for a track orientated bike with a 750m shim head motor

Here’s some more .info for ya. These ain’t mine btw, I borrowed them to copy but I’ve since bought a zx6 front end for next to no money. they will still be in my possession for a few days if you need any further measurements!

A walbro 255 pump fits into a L0/L1 750 pump housing and has the same mounting bolt pattern as a K4 1000. Less plumbing = less pipe work full of fuel exposed to the heat of an oil boiler, its neater and takes up less room.

It'll work if you still put a return in the tank. I've got the bottom of a K4 tank welded into my slingshot tank for when I was doing an N/A EFI conversion, Its all gone wrong since then.....

If you know your coils are in good working order, then get the ignition pickup cover off and check continuity between the CDI and the 2 sets of pick up wires and the gap between the VR sensors and the trigger wheel. If youre happy with those I'd try a good known CDI and that'll narrow your problem down

If its a slabby then it'll have 5 wires coming from the pickup area

Anyone know what make these are? they fit onto my slabby but in unsure if that was their intended use although the bracket off the bottom engine mount sits in the right place

Sprocket carriers are different between the 750 and the 1100 too

Kwak ZX6 fit without a great deal of work iirc

Pretty sure @fiberman will either do something or be able to make you something?

Very pleased this stayed in the family!

Considering the size of the red and white stand there over the last few years I doubt thats too much of an issue

I'll get something up there next year

The fork chart is knocking about in the vault somewhere. In all seriousness, I would just buy the front end you want and make it fit. Worst case scenario you’ll need a slingshot stem to be swapped into the bottom yoke and a little machining in the top yoke. Get your measuring tape out and go try it

I’m still not 100% for the weekend mate, I shall let you know ASAP though

There's bits of his 7/11 build on the proboards site, theres a good article in the vault for it too

Hi Pan, Please take some time to read the rules in General and introduce yourself, you'll get all the help you need and more then

I try my best I know they’re interchangeable, I’ve got a B12 cover on my EF. You might need to buy some 5mm tool steel rod and faff making pushrods

Yes and possibly

You wont need a spacer plate unless you're using the busa rods too.

More of a hammer

@Funkymonkracingwas doing a billet doodah to raise the ride height iirc

Nice one, cheap as fook that was for what it is. Dibs on the rearsets if you break it!

Did you buy it Pete?

Wasn't that crap then!