george 1100

Can run fine but I wouldn't risk in in a big dollar engine. Valve seats can fall out

They tend to crack between the spark plug and valve seat

After you dropped the needles maybe you should've brought your acc pump in earlier then maybe quarter turn increments of the pilot to see if that affect sub 4500rpm. Either or, or a combination of both

Don't forget the accelerator pump also. Start with the default setting and go from there

Check plug colour after a few hard runs Try the jets first. Only do one adjustment at a time. Did you check float bowl heights? Is petcock ok?

Easy fit. Need to fab a rear bracket and from memory, the front bracket needs to be flipped. The rear of tank sits further back so more suited to a custom seat. Petcock works out

Cheers. Shaft size and spline looks the same. The bearing and race are the same also. So far this looks like an easy mod as long as I can find someone to rivet it together

Can you happen to be able to count the output shaft splines or count the hub splines?

Looks pretty close to me

Thanks for that

370Steve, so they made a billet basket, not used the 1000 basket? The 1000 basket looks like it has very similar rivet spacing which would make the process easier. Does anyone have a bandit basket on a bench to measure the rivet spacing?

That's the reason I want to fit one, so I can improve on the hard braking and fast gearing down corners but agree, not a must have.

I'm thinking I might take this on during the winter months but can't find enough info on the web. I've got an excellent 09 1000 clutch assembly but it doesn't look too straight forward so before I pull out the bandit clutch, has anyone ever done this mod that can also share some step by step knowledge.

I'ts possible to disassemble the springs without removing the head

Almost looks like a valve spring seat

Pretty sure they use billet

i found that if you continuously turn the oem tap to prime, the internal cast mechanism that enables it to open, is flimsy cast alloy and eventually wears out and fuel doesn't flow. I also believe in prime, it doesn't flow at full volume. When you turn it, there's a slight internal ramp that opens the valve. You will notice the lever very slightly depresses. This happened to two of my oem taps so far. Pingel only for track bike now

you could get the high comp pistons then play with block spacers

Head cooler on my track bike is mounted upside down and haven't had any issues

Don't worry, I checked out my hair a few times before I bolted them on

Those port pics are the before version. Here are a few of the after

Chain fits and aligns, just use an offset sprocket.

This may give you some ideas. The swing arms are around the same width at the rear. It works but all depends on how much trouble you want to go to

Apparently Annitori make a standalone unit for 240usd with rod which is not a bad option or I rip out the HM one from my cbr and adapt it if possible or go with the Ignitech. Decisions ...... The cbr is basically a commute bike and I rarely use the quickshift.