Fazz711

Use lots of small dot marks evenly spread around the housing and a small amount of bearing retaining fluid. It's a bit of a bodge but will work if you are careful.

Hi bud. Welcome. I would think that the wires coming out of the tank will connect to the wiring loom and not go straight to the clocks. I would look for a connection in the loom that doesn't have anything plugged in. Then check the wiring diagram to see if it matches.

Yes a tube of stainless would be good. 1mm or 2mm longer than the gap between the bearings should be good. If it is a bit long you can always skim a bit off. Not as easy to. Make longer

Not shorter as it puts side load on the bearings. This will make them collapse

Very reliable. Usual suzuki electrical. Reg rec and alternator. Motor fairly bullet proof. Good bike if a little dull

Plus one on the Harris rotax. This is one i am using on my slab

Hi bud. Welcome

No problem mate

Hi bud. Rtfr. Don't think the pics will stay up long.

Unbalanced carbs cause uneven pulses and that rattles the clutch.

Hi bud. Welcome

Hi bud. Welcome

Hi bud. Welcome

4-2-1

Heaps are good. You just need to focus on the potential . Have a plan for where you want to end up.

Hi bud. Welcome. Pics are good

This is the foam out of a slingshot seat that I am going to use for mine probably

I will try and get a photo of the seat with the foam tomorrow

I am going to use the foam out of a slingshot and get it mounted to a Ali base and then recover

Hi welcome

Cheers will try that

Even so it surprised me. Expected to at least have the carbs off. I only turned it over to see if the battery would still have any life in it. And it chugged into life so added some choke and away it went. Tick over was a little rough to start with but once it warmed up it reved fine and ticked over nice. Going to ride it over to a mates at weekend and see how it goes

Yeah I managed to start the SRAD for the first time in years. I need to move it to a new storage area to create room for other project work. I put battery on charger on Sunday and wanted to check if it was changed enough to turn over and it fired up.

As far as I know only the bottom engine mount is different. I'm sure some one more knowledgeable will be able to confirm

Hi