Burnout Posted July 28, 2015 Posted July 28, 2015 So i need a little more clearance between carbs and the frame ,so i was going to cut out a notch to give me extra mm ,any recommendations? Quote
Burnout Posted July 28, 2015 Author Posted July 28, 2015 It will be as i want to fit nos flanges Quote
Duckndive Posted July 28, 2015 Posted July 28, 2015 (edited) It will be as i want to fit nos flangesdrill the underside of the inlet port to fit the foggers .................... Edited July 28, 2015 by Duckndive spilling Quote
Gixer1460 Posted July 29, 2015 Posted July 29, 2015 Or fit an ally carb top ...........and notch that! Quote
slingy1157 Posted July 29, 2015 Posted July 29, 2015 Or fit an ally carb top ...........and notch that!I was going yo say similar about cutting and JB welding a flat of alloy on the carb cap, smoothed on the inside with JB, sanded and painted on the outside, would look ok, and save the frame. Should work fine as long as you don't change the area the slide moves up into. Quote
Captain Chaos Posted July 29, 2015 Posted July 29, 2015 if those are 36mm carbs, using B12 intake rubbers will lower them a bit. Quote
Burnout Posted July 29, 2015 Author Posted July 29, 2015 38mm captain Chaos with matching intake rubbers . Quote
jonny1bump Posted August 2, 2015 Posted August 2, 2015 As Clive said attach to cylinder head itself. Quote
Burnout Posted August 3, 2015 Author Posted August 3, 2015 Decided its easier for me to notch the frame ,going to run cables in there too so makes it a touch easier to do cables. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.