Jdeac

Outer 4

Think I've got it sorted now. Will see tomorrow. Changed the lines. All new clips etc. Run up all good. So check for drips tomorrow. Cheers for the input all

Cheers clive

What clips do you recommend??

Hi all. What's the best scavenge pump to use. Got a facet posi flow on but keeps weeping oil. After shut off left to settle/cool then powered up to drain excess oil

Nice little touch of paint there fboab.

Original arm sleeves. You need to sort the crush tube aswell. Need the linkage from the newer swinger aswell. As the dog bones are a different width. I believe. Have this setup in a 90 slingy

What are their pannel like. And what do ones do they do??

19 row in pic isn't going to work. What the dimensions of a curved cooler?

@no classdo you have any more pics of your setup. I have dyna fuel pump and regulator. Airshifter solenoids under the rider section of the seat. Battery box behind that. Do have some room behind all that though

Cheers. How have you protected them? As I have no rear hugger

She is a little low. Will put pics on tomorrow. Gsx 1100 with gsxr 1100 turbo. What size cooler could fit in that area??

Where do you guys put your oilcoolers. When you run a intercooler. Recently purchased pyro. And would like to add a oil cooler.

As per tittle. Not looking for oe parts. Is there anyone that does repro parts? Looking for a sprint/drag bike. Cheers all

@Wagolacompany in South Africa I believe

Got 1 you can borrow. At the pub bridgwater

I want to run on carbs. As the efi setup is incomplete

Just thought as it was being built for efi. I would need to change the pickup and wheel wouldn't i

Anything I would need to do. Other than plum and wire up as standard??

Hi all. Can I run a low comp turbo motor without all the turbo parts etc. Motor was a recent purchase. I would like to run it to check its all good. If I Put some carbs on it should it start up and run OK.

@clivegtoI thought the clutch cover was oldskool cool. But I guess the scavenge is aswell

I shall update my build thread ASAP @Captain Chaos had a bit of a mad weekend spending and need to make some room/ clear up a little @clivegtolooks very similar

Probably should be moved to forced section. I was just going to go through it bit by bit. Sorry

Motor spec should be Std cams adjustable sprockets mistral worked head bored to 1216 busa rods and pistons spacer plate for above rods knifedged crank steel basket clutch plus lockup direct to head throttle bodies gt2860 snail has micro squirt (looks chopped about) I have the plenum and manifold ( this sit to far forward for my slingy) need new one and loads of other parts This is all new to me and shall be I side project now that I have be re inspired with my slingy build