DeegzARG Posted August 20, 2023 Posted August 20, 2023 I rebuilt the carbs last week with new components from the Keyster kit and the GS1000 seems to be running fairly good. Especially compared to how it was running before. the only “issue” I seem to be having is it takes a while to warm up before the throttle is fully responsive. Would going up a size in the pilot jet be the solution? It’s currently stock at 15, I’m thinking of swapping for a 17.5 I also noticed some white smoke coming out of the right side pipe but that only happens when I first start the bike then it goes away. Any thoughts? best carlos p.s. Also swapped the petcock for a pingel and capped the vacuum port. 1 Quote
Reinhoud Posted August 20, 2023 Posted August 20, 2023 Connect an O2 sensor with gauge, and this tells you if the carburfuckingettors are tuned properly Quote
DAZ Posted August 20, 2023 Posted August 20, 2023 White smoke ?!? , I thought that was for a new pope or something seriously though I usually say black for oil, blue/grey fuel, white is water vapour , so has the weather been damp could it just be condensation drying out of the pipe? Quote
TonyGee Posted August 20, 2023 Posted August 20, 2023 white smoke could be leaking stem seals at start up. 1 Quote
Captain Chaos Posted August 20, 2023 Posted August 20, 2023 3 hours ago, DAZ said: black for oil, blue/grey fuel, in south Yorkshire maybe. Not in the rest of the world 2 Quote
DAZ Posted August 20, 2023 Posted August 20, 2023 (edited) 53 minutes ago, Captain Chaos said: in south Yorkshire maybe. Not in the rest of the world Ok ok I got it arse about tit ..... Edited August 20, 2023 by DAZ Quote
DeegzARG Posted September 2, 2023 Author Posted September 2, 2023 I think the white smoke was water vapor. It’s gone away since. I still notice it’s takes a while to warm up though. Would switching to a 17.5 help with that issue? Quote
DAZ Posted September 2, 2023 Posted September 2, 2023 (edited) What do you call a while ? Can you start it on choke , let it run a couple of minutes whilst putting helmet Etc on ( usually adjusting the choke so the motor doesn't rev excessively ) and ease the choke off ? That's kinda normal, it's not like a fuel injection engine that starts and ticks over straight away Edited September 2, 2023 by DAZ Addition Quote
jb Posted September 3, 2023 Posted September 3, 2023 On 9/2/2023 at 3:57 AM, DeegzARG said: I think the white smoke was water vapor. It’s gone away since. I still notice it’s takes a while to warm up though. Would switching to a 17.5 help with that issue? My gs1000 has k&n air filters and a Vance & hines exhaust but I still found increasing the pilot jets just made it too rich…..that said, I’m in the uk and the climate can make tuning different, but I’d be looking at fine tuning the carb’s again before swapping out the jets Quote
Rijko Posted September 3, 2023 Posted September 3, 2023 5 minutes ago, jb said: My gs1000 has k&n air filters and a Vance & hines exhaust but I still found increasing the pilot jets just made it too rich…..that said, I’m in the uk and the climate can make tuning different, but I’d be looking at fine tuning the carb’s again before swapping out the jets same for me, K&N and Yoshi pipe, running standard pilot jets. Quote
redgs1000 Posted September 5, 2023 Posted September 5, 2023 Did you adjust the fuel screws . mine are 2 turns out bike starts revs and idle's fine Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.