TiZiK Posted January 12, 2016 Posted January 12, 2016 Finally getting around to finishing the assembly of my 1316cc big bore. I have dry blocked it and had the cylinders oringed. When doing final assembly, should I be using a gasket sealant? The install sheet from cometic says to use some, but I'm thinking that since its dry blocked and oringed, I may not need it. Just wanted to confirm and see what others have done. Quote
Gixer1460 Posted January 12, 2016 Posted January 12, 2016 Yes use sealant - Gaskacinch is what i'd use - its like thinned out, non adhesive Evo-Stick and it works! 1 Quote
Markz9 Posted January 12, 2016 Posted January 12, 2016 ray debben at debben performance sells it make sure you leave the window open you will be floating around the ceiling Quote
Gixer1460 Posted January 12, 2016 Posted January 12, 2016 1 hour ago, Markz9 said: ray debben at debben performance sells it make sure you leave the window open you will be floating around the ceiling That's the best bit - don't spoil it! Quote
Markz9 Posted January 14, 2016 Posted January 14, 2016 i Have used the spray on VHT gasket but its a bit messy i think the gaskacinch is a lot better to use Quote
Screwriverracing Posted January 15, 2016 Posted January 15, 2016 Gaskacinch and a bit of yambond round the oil way studs, there are other makes of bond around. a top tuning shop used black silicon round the oil way studs, worked a treat, But only use a thin smeared Cheers SRR Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.