Spirit Posted December 25, 2018 Posted December 25, 2018 I have been told that it is possible to lift the cylinder heads on GS1150's and Katanas without removing the motor from the frame. Is this true? Quote
skelly Posted January 3, 2019 Posted January 3, 2019 Yes. But not with the carbs or zorst attached. 1 Quote
Duckndive Posted January 5, 2019 Posted January 5, 2019 On 1/3/2019 at 8:51 PM, skelly said: Yes. But not with the carbs or zorst attached. And removing the coils gives you loads more room 1 Quote
skelly Posted January 6, 2019 Posted January 6, 2019 So.. Joking aside, yes it is possible. Don't forget to undo the M6 bolt at the front of the head. In fact, undo that one first then loosen the head nuts, the copper washers may have crushed slightly so you may have to bear that in mind. Quote
Screwriverracing Posted January 6, 2019 Posted January 6, 2019 And when you put the washers back on, slide them on a screwdriver then put the end of the screwdriver on the stud and drop the washer down, saves dropping the odd one down the cam chain tunnel. Cheers SRR 2 Quote
Reinhoud Posted January 6, 2019 Posted January 6, 2019 3 hours ago, Screwriverracing said: And when you put the washers back on, slide them on a screwdriver then put the end of the screwdriver on the stud and drop the washer down, saves dropping the odd one down the cam chain tunnel. Cheers SRR And heat the washers up till they're red hot, so the copper gets soft again. Quote
ral Posted February 15, 2019 Posted February 15, 2019 Don’t forget to let em cool again though ah 1 Quote
nachopa Posted February 15, 2019 Posted February 15, 2019 Mmm interesting to know this just in case... Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.