Bandit sprocket cover/motogadget

[Burnout]

So i am going to be using a motogadget mini speedo on my GSXR 11 and i am wondering if i can use this sprocket cover for the pickup ,i do believe its a mk2 1200 bandit (correct me if iam wrong ),

so will it work on the  GSXR with the correct sprocket ? what do i need to make it work ? will it even work ?

 

 

 

[crow]

Yes it should work assuming the motogadget can read the signal (should just be a case of wiring it in right?)

You need a little castellated metal widget that bolts into the end of the output shaft. Same part on bandits & GSXRs from early 2000s

[crow]

This guy

[colinworth79]

just need to drill and tap the end of the output shaft m6.

[zedhead]

Have fun drilling the output shaft!...

[bluedog59]

23 minutes ago, zedhead said:

Have fun drilling the output shaft!...

I got round that little problem by welding the castellated trigger to a sprocket nut. I seem to remember there was a little bit off turning /fabrication to make it sit right but it did the job perfectly.

[zedhead]

I did that as well Bluedog - although the first time I did it it just popped the castellated 'speedo trigger' off as soon as I tightened it up as the output shaft was longer than the thread of the nut! :-) 

[fatblokeonbandit]

I've done 2 of them, on both  the output shafts were case hardened, so the middle was easy to drill, worked a treat

[Burnout]

So where will i find these speedo triggers about i looked on Robinsons but they dont seem to go to the year i need.

 

 

edit .found them

 

Edited April 18, 2018 by Burnout

[fatblokeonbandit]

Speeds rotor 34981-35F00. 

[Burnout]

And as if by magic 

[mick-ne]

Did you ever get this working, I like the idea.

[jonny1bump]