clivegto Posted October 30 Author Posted October 30 2 hours ago, GeorgeEI7KO said: Lovely work @clivegtoShe's gonna be a cracker! Cheers man . Made some temporary dog bones up and pushed it outside. 11 Quote
clivegto Posted November 1 Author Posted November 1 Will welded the back part of the plenum to the front part. I then cut each end off to fit in the frame. Made a couple of ends up to be welded on next. Fuel tap will need moving round 1/3 of a turn I think but I'm going to lift the tank about 8mm as well. 2 Quote
clivegto Posted November 1 Author Posted November 1 1 hour ago, Paulm said: Looking good my chicken loving friend Cheers my jelly bean eating fried, still loads to do before it's a runner but I'm really enjoying working on this. 1 Quote
clivegto Posted November 4 Author Posted November 4 (edited) Inlet pipe for the plenum from the intercooler going over the top of the engine. I'll take the whole bike to get this welded on. Bottom of the tank will need slight modification but not too much. Edited November 4 by clivegto 3 Quote
clivegto Posted November 4 Author Posted November 4 Had a re-think and I may be over complicating it, gonna just get a 50mm stub welded on then use 90° silicone pipe. 7 Quote
clivegto Posted November 6 Author Posted November 6 Knocked 4 oil cooler stays up on my little lathe to support the cooler brackets this evening. 2 Quote
clivegto Posted November 6 Author Posted November 6 A mate found an old invoice from when he had a swinging arm made back in the day which has there old address on which I thought was interesting 1 Quote
TLRS Posted November 6 Posted November 6 On 11/4/2024 at 7:13 PM, clivegto said: Had a re-think and I may be over complicating it, gonna just get a 50mm stub welded on then use 90° silicone pipe. Silly cone tube might keep intake air temp lower too Quote
clivegto Posted November 7 Author Posted November 7 Took a bit of weight out of the middle of the cooler stays and cleaned them up to make them more aesthetically pleasing as Mrs GTO's would say. 1 Quote
clivegto Posted November 7 Author Posted November 7 Picked the plenum up from Wills after he welded stage 3 of it up. Am well pleased with how it's turned out so far . 8 Quote
clivegto Posted November 7 Author Posted November 7 13 minutes ago, Wee Man said: Wowsers! That turned out really nice. Cheers mate, it'll still need sumat to stop it blowing off but ain't worried about that yet. 1 Quote
clivegto Posted Thursday at 05:23 PM Author Posted Thursday at 05:23 PM More parts for the puzzle 3 Quote
Paulm Posted Friday at 10:58 AM Posted Friday at 10:58 AM On 11/7/2024 at 5:44 PM, clivegto said: Picked the plenum up from Wills after he welded stage 3 of it up. Am well pleased with how it's turned out so far . Nice bit of work that is Clive Quote
clivegto Posted Friday at 12:13 PM Author Posted Friday at 12:13 PM 1 hour ago, Paulm said: Nice bit of work that is Clive Thanks, I just cut the bits to shape and Will welded it up. Quote
clivegto Posted 4 hours ago Author Posted 4 hours ago So this afternoon I cut a big hole in the tank. 2 Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.