vern Posted July 9, 2023 Share Posted July 9, 2023 Hi, any advice on getting the swing arm bushes out of a standard 1100m swing arm?? Any help appreciated. Quote Link to comment
spiderpig Posted July 9, 2023 Share Posted July 9, 2023 Good luck, last ones I did disintegrated, outer race completely seized, ended up getting another arm Quote Link to comment
gsxwill Posted July 11, 2023 Share Posted July 11, 2023 (edited) Soaking them with a bit of penetrating oil and some heat should help get them out but a lot of it is down to luck as @spiderpigsaid Also the condition of them can be a factor, if they are totally trashed they always harder to remove Edited July 11, 2023 by gsxwill Can't spell Quote Link to comment
Duckndive Posted July 12, 2023 Share Posted July 12, 2023 I,ve used an expanding foundation bolt in the past but bearings will be useless after Quote Link to comment
slayer61 Posted July 12, 2023 Share Posted July 12, 2023 6 hours ago, Duckndive said: I,ve used an expanding foundation bolt in the past but bearings will be useless after Is that what we call a "concrete anchor" over here? 1 Quote Link to comment
Duckndive Posted July 12, 2023 Share Posted July 12, 2023 (edited) 2 hours ago, slayer61 said: Is that what we call a "concrete anchor" over here? yes similar i used this type Edited July 12, 2023 by Duckndive 1 Quote Link to comment
spiderpig Posted July 12, 2023 Share Posted July 12, 2023 Hadn't thought of that Quote Link to comment
Crass Posted August 11, 2023 Share Posted August 11, 2023 Dremel with care so they are almost cut through then drift out from the other end. They'll just be mullered but the weakness caused by cutting will break them out. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.