Hi,
Need to have my gsxr1100m, 1127cc, motor rebored.
Does anyone know where I might go to get new piston? Suzuki don't do them anymore and there are none left in stock anywhere.
Any help would be appreciated.
Thanks.
Thanks, yes the emulsion tubes do move and I'm not sure why. It's like they are too long. I sent them for a clean and overhaul but the guy says he didn't change them, so I'm a bit stumped. I don't have an Airbox yet, but am looking for one.
Hi,
Ok, the internal diameter where it goes to the inlet manifold is 40mm, which I'm assuming means it is a bst40? But, the book says the needle jet is a p2 which is what is fitted, but it moves by 3mm! Pics attached.
Hi, can anyone help identify which carbs these are on my 91 1100? I had them refurbed and I think the guy had put the wrong needle jets in as they seem to be too long.
Hi,
Does anyone have bulb holders for the dashboard on my 91 1100m? Mine are not serviceable. Alternatively any alternative suggestions?
Chris williams
I have spent the day writing an e mail listing all the part numbers for gaskets, seals and other rings. Be interesting to see how much it costs! Did you change your timing chain? If so doyou know who made it? Thanks.
I am rebuilding my 1100. M.
Just found out suzuki have discontinued the full gasket set. Anyone know of a good quality replacement that actually fits??
Thanks.
Hi. I am rebuilding my 91 1100 engine. What is the best way to get pistons back into the barrels?? Put the barrels on first and pistons through the top? Or crank and pistons into cases and slide barrels on??
Any advice very welcome. Thanks in advance.