Gsx 1100 efe swingarm build in size ?

[tomtom66]

Hello all..

 

Can anyone tell me what the build in size is of the swingarm ?

I think the frame size is off, I thought it was 23 mm but am measuring 23.5 mm, is this correct?

 

Many thanx.

 

[Swiss Toni]

What do you mean by ‘build in’?

[tomtom66]

 It's been some time that I spoke or wrote Englisch .

I mean the width at the Swingarm Pivot ...I think .

I want to get the frame checked if it is straight.. they want the frame with  wheels.. swingarm and fork..

I have a fork and wheel that fit, swingarm and rear wheel, I will need to get, so if the size is off at the pivot witch i think it is ..It won't fit.

 

So......Can someone tell me is the the swingarm at the pivot 23 or 23.5mm

 

Many Thanx

 

 

 

 

 

 

[Captain Chaos]

34 minutes ago, tomtom66 said:

So......Can someone tell me is the the swingarm at the pivot 23 or 23.5mm

That's very narrow. I would think it's at least 200mm 

[Swiss Toni]

I have an EFE arm in the garage. I’ll measure it for you tomorrow. Pin size?  I can’t remember!

[eddiegsx]

Did you mean 23cm not mm?

The swingarm is 230mm across the pivot, approx 235mm with the end caps included.

Hope this is what you need?

[eddiegsx]

Just to add, the swingarm bolt diameter is 20mm (99% sure).

 

[Swiss Toni]

Mine’s 235mm inc. end caps. 

[Swiss Toni]

And, if you’re worried about the frame mounts being slightly wider than the swinger ... don’t! That’s normal. The frame will ‘pull in’ when you tighten the bolt!

[Blubber]

plus... the swing arm has spacers behind the dust seals . at least mine did.

[tomtom66]

Ok.. Thank you all 

 

That was what I needed to know.  I thought the frame is was off bij 5 mm, the frame was modded by someone before I got it and mods have been cut away. So I was not sure if would fit original parts .

Now all i have to do is..see if I can find the pivot bolt somewhere .

Thanx again.