fatblokeonbandit

Expensive but if its a good job its worth it

the offset is 35mm if i remember right

Bugger me thats shiny where and how much shipmate??

Any pictures????

and on my Moto Martin its attached to the frame...

here is my Teapot set up but no room for headlight..

Like this??

Electricity.!!! Mk1 bandit engine and Mk2 loom and ancillaries.. different plugs so all swapped over..

Yes I’ve been reading up on it, Halfords rattle can Matt black I think but seriously I think I’ll redo the white powder coat, or mabey silver

How did the 28 tooth cog fit?? Its bigger diameter than the 26 tooth one, so will not mesh with the drive grear on the back of the clutch juts bend it and break it??? Unless the problem with the alternator not working is that the 26 tooth cog was not engaing with the drive gear on the clutch, not turning and not charging. The 88 1100 should have 28 teeth.??? part number for the gear on a 1100 86-88 G,H,J 22730-06B02 GEAR, GENERATOR DRIVEN (NT:28 1989 1100K 22730-06B03 GGEAR, GENERATOR DRIVEN (NT:28

Whilst in the pub avoiding football and talking bollox as usual, someone said that my frame would have been Chrome or nickle plated?? looks right, but how fekin expensive is that?? or do I do it white again

That’s plan A Dunc, plan B is 8 or 9 inch headlight and cooler at the back ??

Now heed cooler location??

Now the engines in the middle the chain runs is easy

Yes its Nice, just need to find shiny Master cyl with 40mm hole spacing

Fek How’s that happened

Better find some oil and electricity first an oil cooler

I think your right, Jon, it probably didn’t matter if it ran alright, it’s just me being a bit pedantic anyway it’s all lined up, now to do chain run

If it don’t fit twat it with a hammer until, either it fits or it’s broke

So after some jiggery and quite a bit of pokery, it’s in line, ill make up some new shiny spacers when I do the frame in powder coat..

Just checked front spacing and the spacers are different lengths by 5 mm I had them in upside down and back to front!!!

Not a clue shipmate?? It’s a slabby arm no idea how long it’s supposed to be ??

The bars, seat, foot pegs spacing is fine enough room for my fat arse