Flatslides idle mix screw settings ?

[HWB]

Manual for the 38 flatties says std screw setting is 1/8 1/2 maximum. I just want to confirm this. If its the case then its wayyyyyyy different than my cvs which are 2 1/2 turns. I made the mistake of not counting how many turns they were before messing with them

[no class]

when you seat the screws before turning out to final adjustment ….be gentle as the tip can break off and become stuck in the orifice . I had to repair a set of rs36’s that the owner fucked up 

[Gixer1460]

The manual is correct and yes they are waaaaay different to CV's, a totally different type of carb so settings don't translate!

[Duckndive]

Its also best to sync the slides with them of the bike 

[rodneya]

RS36's at 1/2 turn out getting a bit of spitting through the carbs at low throttle opening and a lot of popping through the pipe on deceleration. Should I be going to a bigger pilot. Bike starts easily and runs well.

There is a lot of confusing info out there regarding these cards.