wraith Posted August 24, 2022 Share Posted August 24, 2022 Got a wanted add in but can anybody tell me the length of the MK1 b6 clutch push rod? Thanks Quote Link to comment
jonny1bump Posted August 24, 2022 Share Posted August 24, 2022 Wraith just use piece of silver steel and round the ends off. 1 Quote Link to comment
jonny1bump Posted August 24, 2022 Share Posted August 24, 2022 If doing clutch conversion make longer rod not add ball bearing as in Lee article, you don't want restrict the oil going down centre of shaft. 1 Quote Link to comment
wraith Posted August 25, 2022 Author Share Posted August 25, 2022 12 hours ago, jonny1bump said: Wraith just use piece of silver steel and round the ends off. Got some bar left over from when I made new one for the kat I did have two standard b6 ones kicking about, but now I need one I can't find them It's to go in the b6 motor that's going in the gs550. Quote Link to comment
clivegto Posted August 25, 2022 Share Posted August 25, 2022 When I haven't had any bar to hand I have used 6mm drill bits in the past. Quote Link to comment
wraith Posted August 25, 2022 Author Share Posted August 25, 2022 2 hours ago, clivegto said: When I haven't had any bar to hand I have used 6mm drill bits in the past. just to help home out the seal I've got some mild steel 6mm bar, some stainless 6mm bar and some TI 6mm bar so I think I'm ok for bar at the moment, but if it came to it I've got a load of long 6mm bolts Quote Link to comment
clivegto Posted August 25, 2022 Share Posted August 25, 2022 Needs must some times when clutch tuning 3 Quote Link to comment
wraith Posted August 25, 2022 Author Share Posted August 25, 2022 1 hour ago, clivegto said: Needs must some times when clutch tuning what works, works Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.