Gsx1100er Posted October 11, 2019 Share Posted October 11, 2019 Where do I take the petcock vacuum pipe from on these ? Can I use one of the blanked off outlets on the Carb tops ? Cheers Gaz Quote Link to comment
Jaydee Posted October 11, 2019 Share Posted October 11, 2019 Yes, just attach a pipe from the vacuum on the tap to one of the carbs top. Job done. Quote Link to comment
Gsx1100er Posted October 11, 2019 Author Share Posted October 11, 2019 Cheers mate Quote Link to comment
CockneyRick Posted October 12, 2019 Share Posted October 12, 2019 18 hours ago, Jaydee said: Yes, just attach a pipe from the vacuum on the tap to one of the carbs top. Job done. Wouldn't the pipe ID at each end be quite different, or have you sourced the first tapered fuel pipe Quote Link to comment
Jaydee Posted October 12, 2019 Share Posted October 12, 2019 7 hours ago, CockneyRick said: Wouldn't the pipe ID at each end be quite different, or have you sourced the first tapered fuel pipe I haven't seen the taps vacuum outlet to know the bore size. But it wouldn't be rocket science to sleeve one rubber hose in to another if the bore on on the vacuum outlet was much larger than the take off on the carb top or vice-versa. Quote Link to comment
Gixer1460 Posted October 12, 2019 Share Posted October 12, 2019 Usually one of the inlet rubbers has a take off specifically for this function and its size matches the vac. tap port? Not saying a carb top port won't work but they are really choked down for vac gauge idle set-up and stop the needle flickering too much. 1 Quote Link to comment
CockneyRick Posted October 13, 2019 Share Posted October 13, 2019 On 10/12/2019 at 3:15 PM, Jaydee said: I haven't seen the taps vacuum outlet to know the bore size. But it wouldn't be rocket science to sleeve one rubber hose in to another if the bore on on the vacuum outlet was much larger than the take off on the carb top or vice-versa. i reckon there's a difference, but nowhere near enough to sleeve it down Quote Link to comment
NorthernBloke Posted October 13, 2019 Share Posted October 13, 2019 I fitted a set of these to my GSX1100 and took the feed from one of the carb tops, no issues the pipe size was the same, no sleeving required and it worked fine. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.