t3rse

Jesus! An no I/C or meth injection?

Where did you source that header?

Totally custom IC or did you modify a standard dimensioned one?

That's adorable. It has a nut rest.

In my opinion, bikes with steel frames shouldn't have fairings....

I laughed way too hard at this. I dig the bike though...

Excessively rich will pop too. Lean pops are very sharp, and rich pops are more of a gurgle.

What did you use for paint?

Where might one get the proper tool for the job?

This was my first assumption: forgot to hook up the vacuum line on the petcock... Try riding with the cap cap cracked open as well?

I run 89 in mine, with ethanol. It's fine. Does it warm up ok? Is it acting out when it's hot? Have you tried putting the petcock on reserve?

I've been told the MK2 are better because the slide guides won't wear out like the BSTs will. I also have both sets, including rubbers, but I've never bothered to fit the BSRs. Keep in mind the BSRs have 4 jets vs the 3 on BSTs.

I was on two of the old sites for a very long time, and now I have no post count and have to put in bullshit posts like this just to get my count back up high enough to buy shit.

That's pretty slick

I had a standalone on my old car called SDS which just has two magnets for the pickup, a high and low signal about 10 degrees before TDC seaparted 180* on the wheel. Two magnets was enough for batch firing. I assume with such low resolution you'd have to use hysteresis to calculate things...