B12 Generator in Slabby

[nightrider]

I'm putting a donor B12 Motor in a Slabby 11 Roller.

B12 Gen. has different connections then Slabby Gen.

Can I just throw a 1052 Gen. (which I have loads of) or am I going to have to figure out the different wiring (I don't have a B12 Harness)?

 

Edited May 28, 2018 by nightrider

[Duckndive]

1 hour ago, nightrider said:

I'm putting a donor B12 Motor in a Slabby 11 Roller.

B12 Gen. has different connections then Slabby Gen.

Can I just throw a 1052 Gen. (which I have loads of) or am I going to have to figure out the different wiring (I don't have a B12 Harness)?

 

you can bolt the Slabby one on if you swop the gear for the blandit one.....

[nightrider]

Copy that Duckndive

Thank you!

[Nickel]

Be aware using the correct iginition pick up plate in combination with the correct cdi.

Slabside has double pick up and bandit only single.

[MeanBean49]

57 minutes ago, Nickel said:

Be aware using the correct iginition pick up plate in combination with the correct cdi.

Slabside has double pick up and bandit only single.

You can still use the slabby pickup with bandit cdi, you just use one pickup and leave the other disconected.

This post is about generators tho ;-)

[CockneyRick]

As DnD says, gear swap & 2 wires. Red to Batt+ Orange to fusebox/switch feed.

[nightrider]

Thanks CockneyRick

All my gear is 1052 so this is the way I'll go.

[nightrider]

1 hour ago, MeanBean49 said:

You can still use the slabby pickup with bandit cdi, you just use one pickup and leave the other disconected.

This post is about generators tho ;-)

So as I only have 1052 harness & CDI, I should swap out my pick-ups/plate and switch then,

[CockneyRick]

If you got one then might as well  

[nightrider]

Oh I have a few of those

[nightrider]

I have a 1987 750 Gen. with the same Tooth count. I assume I can use this instead?

[CockneyRick]

Should be ok, i know the 7 & 11 are different teeth. Just check depth to be sure  

Edited May 28, 2018 by CockneyRick