KennyKak Posted July 3 Posted July 3 So I've put my powerscreen engine into the 750 slingshot frame and all but one of the mounting holes is lining up. The front mount on the break away frame is quite a bit out. Have I fucked something up here of is something else fooked. BTW when I bought the frame it had been fitted with a bandit 12 lump and the front mounts have been messed with Quote
clivegto Posted July 3 Posted July 3 Should fit straight in if the 750 mounts are the right way round. Fit all engine bolts loose before tightening any of them up Quote
fatblokeonbandit Posted July 3 Posted July 3 Has the rear bottom mount been enlarged to 12mm or a smaller 10mm bolt fitted and holes left at 10mm???? Quote
KennyKak Posted July 3 Author Posted July 3 1 hour ago, fatblokeonbandit said: Has the rear bottom mount been enlarged to 12mm or a smaller 10mm bolt fitted and holes left at 10mm???? Bored ot to 12mm. Quote
KennyKak Posted July 4 Author Posted July 4 Yeah it's an L/M and can't find any mounts right now. And don't have enough of a ranking to go on the wanted page on here Quote
DAZ Posted July 4 Posted July 4 50 minutes ago, KennyKak said: Yeah it's an L/M and can't find any mounts right now. And don't have enough of a ranking to go on the wanted page on here I thought it was 50 posts ? You should be able to 2 Quote
GeorgeEI7KO Posted July 5 Posted July 5 Just make some new mounts from some 6mm ally. Job done innit? 1 Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.