1993 GSX750F Exhaust Replacement

[Courtney]

Hi - I currently have a 4 into 1 system but am starting to look for replacement stainless steel down pipes / collector box. I've been scouring Eblag (uk) but all systems are for newer models. My question is what (if any) other models / years are likely to fit or is it model/year specific?  I've seen some downpipes for a 92 600f but flanges look different. Any suggestions would be appreciated.

[wraith]

First, welcome to oss.

Best thing to do, is remove the 750 motor put a b12 in it with a turbo 

You will find any of the 600/750 oil cooled engine exhaust will fit, you may need to make a new bracket for the end can mounts.

The other thing you will need to look at is, if yours is the model with a 4-1 fitted as standard you may need to swap the sumps and oil pick up for a model that has a 4-2 exhaust or you may find the exhaust hits the sump.

[Courtney]

Hi - thanks for your welcome & quick reply. 

I've only recently purchased the bike. The current set up is not original - it should have had two 2 in to 1s. The current one looks a bit 'Heath Robinson.' Some numpty has cut one of the centre stand mounts off to make it fit. Something I'd like to reinstall in the future. 

[Losiu]

Hi. I have a complete exhaust system from the GSX1100F... but I also have an engine from B12 and a few other improvements ... the oil sump was left with 750 - it is symmetrical and fits under this exhaust.

[Courtney]

Thanks for your reply

Looks great - so does a GSX1100f exhaust fit a GSX750F????

[Losiu]

The exhaust manifold is higher.  In the 750 with a short stroke will interfere with the fairing and... it will be very low above the ground.

[Courtney]

Thanks - I'll stick with the quest for a replacement for the aftermarket 4 in to 1. 

[wraith]

You will find the b12/gsx1100f and gsxr1100 exhaust will fit but as above, the down pipes are longer so will sit lower than the standard 750 ones and my interfere with the fairing.

[Courtney]

Thank you - you are a mine of information. 

[Ivan]

Gsx1100f original exhaust is extreme heavy and most are not in superb condition.

 

My 750f has a stainless slabby micron? 4 in 1, fits with original sump

Edited August 20, 2022 by Ivan

[Courtney]

Now that is beast Ivan!

[Upshotknothole]

Teapots didn't really change much between first and second gens. Any of those 600/750 exhausts should fit. And stay away from all the OEM stuff, as others have said, they were extremely heavy.

[Courtney]

Thank you for the advice I'll have a look on Eblag.

[Courtney]

I'm sure there's an auto correct on here as my typing isn't that bad.

[slayer61]

2 hours ago, Courtney said:

I'm sure there's an auto correct on here as my typing isn't that bad.

  You have to try hodna!