Blue
-
Posts
668 -
Joined
-
Last visited
Content Type
Profiles
Forums
Events
Posts posted by Blue
-
-
What fittings would I need to sort my oil cooler hoses out? AN-8? 35 or 45 deg?
-
What size sleeve do I need on a 1127 engine for the lower rear engine mount when fitting into 750 frame? Is it 12mm tube by 1mm wall? Thanks
-
What was wrong?
-
I have a sprint steering damper that I thought I might be able to make use of, too long to use in front of tank!
-
Yoke to spindle?
-
Sorry
But bike is saved 
-
Only a throttle cable
-
Wife said "cheeky b'stard"
-
2
-
-
What else should I replace that works fine but looks in a state?
-
Panic over, I tested battery terminal to engine & got 0.02v then noticed bolt holding eye in place was loose doh!
-
2
-
-
I've just completely rewired the bike
-
What would be the reason an earth lead is getting hot whilst turning engine over?
-
Anyone able to have a look at there's to see if mines wired correctly before I add the b/w wire. Thanks
-
Like this
-
20 minutes ago, Gixer1460 said:
Steering Damper what?.................usually attached to frame?
Yes usually
-
Steering damper
-
Didnt think coils were on the side of the engine
-
Do you think it be ok to make a bracket that'd be held in place by either the cam cover bolts or the cylinder bolts that are used to make cam links?
-
1) Bandit 1200
2) gsxr 1052
3) gsxr 1127
-
2
-
-
Yes they have same part number according to http://www.alpha-sports.com/suzuki_parts.htm
-
1
-
-
6 hours ago, Ben Slabby said:
They need replacing with hard nylon bushes ideally, but they keep the MOT man happy.
Are they tapped into frame?
-
Not able to weld anything as yokes are anodised & frame is powder coated. Top yoke is thicker than standard so I don't think there's enough room to fit a steering damper bracket under top nut. It's either make a bracket & drill the front of the bottom yoke to make a stop or fit a side damper with a bracket coming off one of the 3 (or all of em) pinch bolts to a bracket off the side of the engine or frame & use that as a stop
-
For those who have fitted usd's what have you done for lock stops?
-
I thought it interesting due to the slingshot frame being used & the engineering/parts that went into it. Sorry to have caused a ho ha
Sorting oil cooler hoses
in Oil Cooled
Posted
I want to get rid of this lot & start again