wraith Posted October 12, 2018 Posted October 12, 2018 On my harness i have two block connector going to the cdi one has 4 wires the other had 3 wires but the cdi (gsx1100f and also a spare early b12) Had 4 pins and 4 pins, the block fit as they should. So is one of the pins in the cdi part a extra pin?? The wiring diagram shows 4 and 3 wires on both the gsx1100f and the gsxr1100 (1127) Thanks. Quote
CockneyRick Posted October 12, 2018 Posted October 12, 2018 4 pin block (bottom) you should def have all 4 6 pin block you should have at least top L & R plus bottom R. That's minimum you need 1 Quote
wraith Posted October 12, 2018 Author Posted October 12, 2018 Mmmm, just checked I've got on the 6 block a black/red bottom left, yellow bottom right, black/blue top right, which is right colours to the wiring diagram. Quote
CockneyRick Posted October 12, 2018 Posted October 12, 2018 Yellow was probably Green that's faded. Tacho wire is not needed unless you have/want one 1 Quote
Gixer1460 Posted October 13, 2018 Posted October 13, 2018 13 hours ago, CockneyRick said: Yellow was probably Green that's faded. Tacho wire is not needed unless you have/want one No - yellow is correct along with blue/black - they are GSXR 1127 pick-up colours. A GSXR doesn't have that interlock shite either! 1 Quote
60Greyhound Posted May 7, 2020 Posted May 7, 2020 10 minutes ago, wraith said: @60Greyhound how's this. Thanks! Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.