Jpich85 Posted September 2, 2017 Posted September 2, 2017 After having a ride on the bike yesterday I noticed a bad flat spot between 5k-6k I've read that it can be a problem on the 1990 bikes but wondered if anyone knew what could be causing it? It's a standard bike with a micron exhaust system and air box but I haven't looked inside the carbs yet to see if any previous owners have modded then at all. Cheers Quote
Captain Chaos Posted September 2, 2017 Posted September 2, 2017 mine had the same, don't know what exactly caused it but I do know that an 1100 engine cured it. 1 Quote
banoffee Posted September 6, 2017 Posted September 6, 2017 Dyno run? Read the dynojet troubleshooting guide? Quote
no class Posted September 6, 2017 Posted September 6, 2017 Close enough to cruise rpm..... check the needles for wear .... they tend to rub on the emulsion tubes during throttle changes at higher rpm's from intake suction ..... what may appear to be minimal wear can actually change fueling characteristics ......easy fix . Remove top cap and pull out the slde assembly..... check the needle .... replace if shape has been altered . Quote
Jpich85 Posted September 6, 2017 Author Posted September 6, 2017 (edited) Thanks guys I'll give that a try on the wknd and see if I can find anything, Edited September 6, 2017 by Jpich85 Quote
martyngsxr Posted September 7, 2017 Posted September 7, 2017 i have a 1990 750 running a full micron system standard airbox with k&n filter fitted no real flat spots as such to talk about dyno time will probably help as stated above Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.