Sprocket cover

[clivegto]

Any one know what sprocket cover I have hear & the push rod length required for it. Was grey before I painted it.

[Gsx-Mutattack28]

a hydraulic clutch cover for a gsx1100 possibly a B12...  push pin 101mm i believe, i may be wrong on size of pin

[clivegto]

This is a b12 one, its more the push rod length I need as no adjustment on these.

[Paulm]

B12 pushrod is 80mm clive.

[clivegto]

80mm on the top one is to short.

[fatblokeonbandit]

Depends what engine its on??

[clivegto]

Gsx 1100f

[slinger]

If its the same part no as 1100k it will measre approx 100mm

[clivegto]

Have now put a 1100k 100mm one in, It will engage 1st gear will not change to second & will not drive when clutch lever is released. Why ?

[fatblokeonbandit]

18 minutes ago, clivegto said:

Have now put a 1100k 100mm one in, It will engage 1st gear will not change to second & will not drive when clutch lever is released. Why ?

Coz its too long...

[clivegto]

1 minute ago, fatblokeonbandit said:

Coz its too long...

I thank you, thats what I was thinking but you have confirmed it.

[clivegto]

You were right FB shortened  the push rod 1mm & it now works a treat.

Edited April 30, 2017 by clivegto