Gsx-Mutattack28

Rivnut tool arrived. So going through install the 09-14 cbr600rr passenger rearsets. Don't mind the placement on this pic as I had them backwards Also got the top triple drilled for the new guage setup Waiting on a few more Motor pieces to complete the conversation. But nether the less more to come Cheers fellas

Cheers fellas more to come

a hydraulic clutch cover for a gsx1100 possibly a B12... push pin 101mm i believe, i may be wrong on size of pin

Have you done a compression check. If low on compression that's going to affect BHP

I am going to rework it anyways. Thanks to who likes it Well motor showed up today. Got to work converting it from hydraulic to cable. Accomplished! Ordered a set of bandit 1200 headers New ballistic evo2 battery. Swap the crankcase breather cover, to the 600 one. An the engine fits like a glove now.. Cheers fellas more to come

First coat of resin with layer of carbon Second coat Going for 6 total coats of epoxy resin Cheers fellas

Right but not enough load to build up enough force to buckle the otherside, to allow the modified section to open up. I will watch closely as it gets shakin down. An see where it goes. Appreciate the concern

We will see. I have faith in my calculations, If you wanna think about it, where is the most direction of torgue? Forward, chain side... I would love to see the motor torgue that swingarm forward an snap the lateral on the chain side.

Thanks Dan appreciate it lol

so i figure i would start a new thread instead of [posting on the old thread... can get up to date with the the build here http://www.customfighters.com/forums/showthread.php?t=104129 Modified frame Gsxr1000 rear swingarm 1998 Scrad gsxr750 from end 07 zx6r subframe an tail molded together with tank an seat. Custom undertail dual exhaust Powder coated myself An now I will be putting in a 92 gsx1100. Motor arrives in a couple days Cheers fellas

it was braced up behind that filler plate i put in there.

I know this thread is a little outdated but I figured I would post up my 1997 gsx600 transformation Modified frame Gsxr1000 rear swingarm 1998 Scrad gsxr750 from end 07 zx6r subframe an tail molded together with tank an seat. Custom undertail dual exhaust Powder coated myself An now I will be putting in a 92 gsx1100. Motor arrives in a couple days Cheers fellas