Jdeac Posted September 28, 2023 Share Posted September 28, 2023 Hi all what's the setup for ring cap position on. Busa pistons in oilcooled motor?? Cheers in andvance Quote Link to comment
Duckndive Posted September 28, 2023 Share Posted September 28, 2023 same as oil cooled Quote Link to comment
Jdeac Posted September 28, 2023 Author Share Posted September 28, 2023 (edited) This is not something I've done before. I have a manual though. But I don't see anything about the 2 rings above and below the oil ring if you get me. Pic is of 1. They all came out different positions Edited September 28, 2023 by Jdeac Quote Link to comment
Pegleg Posted September 28, 2023 Share Posted September 28, 2023 I've always put them in with ring gaps out of line. I have read that they rotate anyway so not to worry. Quote Link to comment
Duckndive Posted September 28, 2023 Share Posted September 28, 2023 All in the manual 2 Quote Link to comment
imago Posted September 28, 2023 Share Posted September 28, 2023 22 minutes ago, Jdeac said: This is not something I've done before. I have a manual though. But I don't see anything about the 2 rings above and below the oil ring if you get me. Pic is of 1. They all came out different positions You treat the three parts of the oil control ring as if they were separate rings. So top, 90-120 degrees round for the expansion, then 90-120 round for the bottom. 2 Quote Link to comment
Jdeac Posted September 28, 2023 Author Share Posted September 28, 2023 OK. I now get it. Cheers Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.