Swinger swap

[Gsx1100er]

While collecting parts for the 400 Teapot rebuild, I have a few spare bits laying around.   I bought a gsx600F ( minus engine for all the little bits and pieces I was missing ) dirt cheap.

The frame ,forks , rear end and wheel are propping up the shed at the moment but I also have a couple of bits left over from the 7/12 build i did awhile back.

There maybe a future project here but just wondering if anyone has put a GSXR 750 slingshot swing arm and linkage into a a GSX600F frame. I have the arm , shock and dogbones but no rocker.  If anyone has done this swap which rocker have you used ?

Cheers

Gaz

 

 

[wraith]

There where two people doing swaps like this in the project section last year/ start of this year with some nice info.

[fatblokeonbandit]

It tried fitting a bandit swinger to a 750 teapot but there was no way the pivot was too narrow and the frame rails holding the rear foot begs  and body work was all in the way,,.. could be done but I put it in the way to difficult pile

[Gsx1100er]

Thanks boys, shed prop it is then

[Lachie04]

Yeah it's a bit of work to get it in there

That's a gsxr600 arm but seen with a braced 750 arm also same need to move the bottom rail

Edited September 28, 2023 by Lachie04