Hayabusa Swing arm to a '99 Bandit 12

[wraith]

3 hours ago, Crazy88 said:

Yeah Im going to be using the front end, hoping for the rear end hence this thread, see what i can sell the rest for if at all..rofl

Frames don't go for much, engine (take it's the 750) somewhere around £250-350 carbs £200+++

Eblag prices 

[Crazy88]

The frame has been cut to shit so nothing will come for that, the engine is a 750 slabbie but it was running although covered in bad blue paint...not sure what the carbs are as yet but any cash is good cash for a project

[wraith]

Carbs look like the standard slaby 750 flat slide, and are well sort after, seen them going for lots of money on that site 

[Tony Nitrous]

On 8/5/2022 at 11:11 PM, Crazy88 said:

Busa  6 inch? 

All Busa rear rims over the last 22 years are 6”.

They are slightly different fitment.  I have all 3 sat here.  99-07 Gen-1, 08-20 Gen-2, 21-22 Gen-3. 

The 1340 B-King and Gen-2 use exactly the same rear wheel but a different cush drive hub. One is taller than the other. 

 

[clivegto]

44 minutes ago, Tony Nitrous said:

 

The 1340 B-King and Gen-2 use exactly the same rear wheel but a different cush drive hub. One is taller than the other. 

 

Which one is taller. 

[Tony Nitrous]

1 hour ago, clivegto said:

Which one is taller. 

I “think” it’s the B-King but I’ll try and find the measurements. I did have a pic of the two sat side by side on the bench and the difference was very noticeable. The wheels are the same. Forks swap but the Busa is firmer. Shock swaps but the Busa raises the Kings rear a bit. Swingarm doesn’t swap, suspension is offset to allow for under seat exhaust.