Nocke Posted November 23, 2015 Share Posted November 23, 2015 Hello, hope someone can answer my question :-)When i use this Kit, must be the original/inside Oillines to the Cylinderhead closed, or is it possible to leave them opened?Thank´s for your help!Nils Quote Link to comment
Sweary Bob Posted November 25, 2015 Share Posted November 25, 2015 If you've got the engine apart you might as well block the oil way in the top of the block. if the engine is built don't worry as the external oil lines will just be another passageway to the rockers for oil. 1 Quote Link to comment
Phill106 Posted November 26, 2015 Share Posted November 26, 2015 Anyone know where to buy these? Iv been looking around but I'm at a blank. I did message fastbyme but got no reply, so is there anywhere else? Quote Link to comment
vizman Posted November 26, 2015 Share Posted November 26, 2015 i'll give loopie [fastbyme] a shout today, he's probably not checked his messages. Quote Link to comment
vizman Posted November 26, 2015 Share Posted November 26, 2015 @Phill106 just spoke to loopie email him fastbyme@hotmail.co.uk as he has the kits... Quote Link to comment
Phill106 Posted November 26, 2015 Share Posted November 26, 2015 Cheers viz iv emailed him Quote Link to comment
Sweary Bob Posted November 28, 2015 Share Posted November 28, 2015 If not Dave, try Stuart at Warpspeed racing. He should have em. Quote Link to comment
Nocke Posted November 28, 2015 Author Share Posted November 28, 2015 Thank´s for your answer Sweary Bob! I leave them open Quote Link to comment
nightrider Posted November 28, 2015 Share Posted November 28, 2015 Is there any advantage in blocking them? Quote Link to comment
Gixer1460 Posted November 28, 2015 Share Posted November 28, 2015 Advantage is increase in oil pressure, reduction of oil temp by not passing oil through the hot block and avoidance of the notoriously leaky block / cases joint. Easy enough to do - tap hole M6 and add grub screws - job done. 1 Quote Link to comment
Phill106 Posted November 28, 2015 Share Posted November 28, 2015 If anyone was wondering about a set of these daves priced at £160+p&p Quote Link to comment
nightrider Posted November 29, 2015 Share Posted November 29, 2015 Advantage is increase in oil pressure, reduction of oil temp by not passing oil through the hot block and avoidance of the notoriously leaky block / cases joint. Easy enough to do - tap hole M6 and add grub screws - job done.Ohhhh right, seems so obvious now Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.