7/12 - Sprocket Cover change

[Brians 7/12]

Soooooo... if my memory serves me correct... I need the Slabby 750 cover to fit the B12 engine so it’ll fit in the Slabby frame... issue I have is I have the speedo sender built in to the cover... my thoughts were would one of those fish looking aftermarket sprocket covers designed for the K series B12 fit in fine with the Slabby frame !? 

[wraith]

Can't you just chop some of the sprocket cover off to make it fit? 

Pics may help.

[Brians 7/12]

Great idea... but will probably need a fair amount of chopping... think I’ll take the gamble if I see a ‘fish’ one come up cheap... or buy a new one !!  

[wraith]

You will also need to sort out the gear lever.

Can't you drill and mount the Speedo thing in the 750 cover?

[Brians 7/12]

Possible... but not with my skills !!  

[Gnome]

1 hour ago, Brians 7/12 said:

Possible... but not with my skills !!  

I'm stripping an engine Brian, and it's my first time (giggity). 

You can do it! 

[Captain Chaos]

2 hours ago, Brians 7/12 said:

Great idea... but will probably need a fair amount of chopping..

I'm not too sure. If you look at where the rear most bolt is (the one closest to the speedo sensor) you can see that it's on the edge of the B12 cover. Should fit.

Gear lever is easy, I drilled a hole in my B12 cover and mounted it.

[Brians 7/12]

28 minutes ago, Gnome said:

I'm stripping an engine Brian, and it's my first time (giggity). 

You can do it! 

You’re a braver man than me !!