ELLESS Posted November 2, 2019 Share Posted November 2, 2019 Sorry, if this have been asked a hundred times, but what are your opinion about drilling the slides by 3,2 mm. 0125" and cutting off 2 coils from the spring,all to the Mikuni BST36. Quote Link to comment
wraith Posted November 2, 2019 Share Posted November 2, 2019 Just get a carb kit and do it right 1 Quote Link to comment
ELLESS Posted November 2, 2019 Author Share Posted November 2, 2019 Ok, thanks! Quote Link to comment
dupersunc Posted November 2, 2019 Share Posted November 2, 2019 Yeah you'll get the correct dynojet 3.2mm drill then. Not felt any difference personally. Like the breather set-up. 1 Quote Link to comment
MeanBean49 Posted November 2, 2019 Share Posted November 2, 2019 Dont bother wasting your time with a jet kit, bit of dyno time, a, set of jets to suit and shim stock needles if needed 1 Quote Link to comment
wraith Posted November 2, 2019 Share Posted November 2, 2019 Drilling the slides with a 3.2mm not a problem, the cutting the spring I don't like, I'd ring Dyna and order 4 springs from them 1 Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.