Goo'Roo Posted September 4, 2019 Posted September 4, 2019 I've bought a MAXXECU mini for my bike, and it can command only 4 injectors. My target is to get 320-350cv with 100-102 commercial petrol. No E85 in Italy. Do you think that 550cc injectors are enough? Quote
Arttu Posted September 6, 2019 Posted September 6, 2019 550cc/min should be enough for something between slightly over 300hp and 400hp. Depending on efficiency of the engine and some other variables. Quote
Goo'Roo Posted September 6, 2019 Author Posted September 6, 2019 Mmh, i thought they could be enough. Engine is a 1216 with ported M head and M cams, chargecooler and a pretty big turbocharger. I'm looking for a efr 6758, but the price at the moment is slowing everything down. Quote
homer Posted September 6, 2019 Posted September 6, 2019 16 minutes ago, Goo'Roo said: Mmh, i thought they could be enough. Engine is a 1216 with ported M head and M cams, chargecooler and a pretty big turbocharger. I'm looking for a efr 6758, but the price at the moment is slowing everything down. Silly money... Quote
manden Posted September 18, 2019 Posted September 18, 2019 Look at the siemens deka 5 injectors. Low latency and dead time. Developed for turboed motorcycles and fair priced at around 70$ each flowmatched and new. The one I've used is 800cc at 3bar. I don't know if there is other sizes. Quote
Goo'Roo Posted September 21, 2019 Author Posted September 21, 2019 On 9/18/2019 at 8:28 PM, manden said: Look at the siemens deka 5 injectors. Low latency and dead time. Developed for turboed motorcycles and fair priced at around 70$ each flowmatched and new. The one I've used is 800cc at 3bar. I don't know if there is other sizes. Do you have a link or a code? Just to understand the injector family and if they're suitable for my application Quote
manden Posted September 29, 2019 Posted September 29, 2019 I'll post them when I get home wednesday Quote
Goo'Roo Posted October 3, 2019 Author Posted October 3, 2019 http://www.siemensdeka.com/product/60lbh-siemens-deka-high-impedance-short-style-with-ev1-connector-fi114962-37-5mm/ I think that they're perfect for my application. Very very compact Specifications: Coil Resistance: 12.5 Ohms / High Impedance / High-Z (No ECM driver modifications required) Static Flow Rate @ 43.5PSI ( 300kPa ) w/Gas: 60 lb/hr = 630 cc/min = 453 g/min Static Flow Rate @ 87PSI ( 600kPa ) w/Gas: 85.7 lb/hr = 900 cc/min = 648 g/min Gain: 0.11ms/mg Offset: 0.055ms Turn on time @ 14VDC: 1.14ms Turn off time: 0.85ms @ 600KPa Connector: Minitimer EV1 Series: DEKA 4 ( DEKA IV ) Orifice Type: Multi-orifice Spray Pattern: 30 Degree Spray Cone Factory fitted with Viton upper and lower o-rings 37.5mm end to end, 14mm oring 1 Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.