Wiring issue

[caferacerdan]

So after shortening a standard b12 loom and throwing it on the bike I have run into an issue with getting no spark

Bike turns over ok though

Things I have checked:

It turns over so that eliminates killswitch and clutch/sidestand switch (both of which I bypassed anyway)

Getting 12v to the O/W coil wire

Magnet and resistance on pickup sensor is good

Tried 2 cdis and 2 lots of coils both of which measured ok on ohms

Any ideas?

[Captain Chaos]

resistor in the ignition lock?

http://oldskoolsuzuki.info/archives/2515

[Blubber]

Resistor would be my first try too.

 

And I am pretty sure that:

- the side stand switch ( in combination with the gears) and the  kill switch....  Both kill the ignition.

- Clutch switch prevents the starter motor from turning whilst pressing the starter motor. 

 

Please correct me if wrong. Its been a while since I worked on a Bandit 

[Captain Chaos]

50 minutes ago, Blubber said:

the side stand switch ( in combination with the gears) and the  kill switch....  Both kill the ignition.

and the starter circuit.

[caferacerdan]

Checked ignition and resistor is present and reading 99 ohms(not quite 100 but close enough).

Sidestand and clutch switch I straight wired the wires together to bypass

Was in neutral and neutral switch works as light is showing up on dash

[Blubber]

- Does it have a tip over sensor?

I know of people whom fitted these up side down.

[Captain Chaos]

did you refill smoke after shortening the loom?

[caferacerdan]

no tip over sensor  and luckily no smoke either! just no spark

[richyrich]

Where did you shorten it , triple check all those wire colours match, all the circuits still made, Is there volts going into coil , tell us how it goes 

[caferacerdan]

15 hours ago, richyrich said:

Where did you shorten it , triple check all those wire colours match, all the circuits still made, Is there volts going into coil , tell us how it goes 

shortened all the front end (switchgear, lights and speedo) all wires connected correctly, all have continuity and there are 12v going to the coil on the live wire

[Blubber]

Loose wire from the signal puls timing thingy?