CockneyRick

CV34s & as far as i'm aware this is a std needle. Only has spring/washer/O ring at the tip end

Already off the bike, i'll do it in a bit

I have CVs on mine, i can remove one & take pic if you like?

I was about to say ones for VM26s & other for CVs but your bike has 26s on? The "kit" should be for your carbs, so not sure where that goes wrong? Unless the screws that have broke (3 of them?) are wrong for carbs & that's why they broke, just too pointy?

I spose the downside to doing this, is there's no off position?

Pretty sure they're all the same

Sorry, but saying CO is even worse than the original fuck up post

Engines are pretty solid, not much to look for that isn't real obvious. Go for a GSX1100F engine as they're the same but quite a few people are unaware & tend to be a touch cheaper

CO2? Since when we been feeding in CO2?

So some numpty has used 1 pipe to join the 2 vent hose spigots?

They all have a Vac, plus how did you disable yours?

Found out, you put emulsions in & the cutout at top of emulsion then faces back & determines which way guides go in

Stripped, cleaned & about to reassemble but i noticed a problem? On the Slide guides there's a hole on the plastic tube that holds the emulsion tube. Only 1 big hole, but does the guide hole face forward or backward? I'd guess forward, but who knows? Guides can go in either way round so not much of a clue there. Pics show front & rear & the parts fische doesn't show them apart!

So the fake raised race style filler edge is a bigger tank?

3 months late, just sold mine with a fair bit of spares

I stand corrected

Hang out for a 1100 swinger too, slighty longer wheelbase

You should sell me the smallest one @clivegto

Aye, even reasonable ones have had the subby butchered! Just sold a good one with quite a few bits here for £300 i think? Memories not what it was!

Yes, but a lot of pissing about & not weorth the trouble. Stick with Slabby/Slingy 85-92 frames

Slab 750 was solid frame, 1100 had a removable frame rail for the bigger engine removal

Glad that was cleared up

So the previous thread about my 44mm tap was for a GS1000 tank. The other thread was about a stripped thread where i didn't mention size, didn't know there were 2 sizes on Slabby tanks as well!

Which one had the smallest capacity & how would i know what one i have?