1100fred

Don’t need to swop the rotor on the engine it’s the same and if you have a mk1 bandit cdi it plugs straight in

You’ll need to lift the tank at the back approximately 10mm otherwise it’ll sit on the rocker over , another option on the fuel tap is fazer600 it’s only on/off but very cheap on that site

Inazuma 750 ‘s have Keihin cvk carbs not mikunis as standed

Keep the inazuma loom that b12 engine will plug straight in

The shocks were aftermarket off eblagg , the forks were off gsxr600 k4 with gsxr750w yokes to keep the original speedo drive and it was a pain to get it all to fit

No not had the bike running that’s as far as it’s got the engine hasn’t been etched primed the instructions say to degrease and lightly sand before painting a freind did his engine with it last year and his finish was good

Yes the piece of aluminium is the 10mm tank spacer I’ve used Simoniz gloss black engine enamel to paint it when I put the in I swopped the electrics to suit the loom I don’t know if the bandit cdi is a straight swop it would be interesting to find out if anybody has done it like I say if you look on that web site or part sights on gsx1200 frames the seem to be relocated up between the frame rails I’ve used a slabside rocker cover because it’s smaller than any other and I still had to bend the bracket to get it over the cam towers

I have just put a gsx1100f engine in my inazuma frame yes have to drill the bottom engine mount Raise the tank at back 10mm to clear the engine I’ll be using pod filters so I didn’t try lining the air box up the only issue I’ve found is getting the rocker cover on/off is the coil brackets get in the way I had to bend it I believe on the 1200 inazuma suzuki moved the coils up between the frame rails to get the clearance

Credit were it’s due OSs is a gold mine of information

I’ve got a gsx1100f engine That’s got a dragging clutch can you tell me what the Suzuki mod for it is thanks

The rearset look to be made by promach engineering

45mm

Hope this is some help

I have a huc frame sat in my garage and thought the. Swing arm pivot could do with a bit of improvement would extending the plates a lot like the Norton frame be a good way of going with this or is there another solution one of the reasons I ask is that I've never read anything about how they actually ride or handle