CV Carb mod to replace plastic washers, which locate under needle circlip that wear out.

[jonny1bump]

I've not got any left, I asked Lee to see he has odd set, this really will be the last if we have.

[Panos]

18 hours ago, jonny1bump said:

I've not got any left, I asked Lee to see he has odd set, this really will be the last if we have.

Ok fingers crossed then , thank you Jonny

[jonny1bump]

Panos sent you message, this really is now the last set, we  not got any more stashed.

[jonny1bump]

George only just seen your message on this topic, hope your  sorted, I presume you will make them yourself.

[Crass]

So as I said in my carb rebuild thread I would measure a brand new set of OEM plastic washers, I thought a better place to post the info was in this related sticky thread. The diameter of the washer is 8.7mm, it is 2.5mm thick and the centre hole (not as easy to measure) is ~3mm in diameter.