Bandit wheel in standard Kat forks?

[Mak595]

Will a B12 wheel/ discs fit into the standard 1983 Kat 37mm forks?

Also is there any brake adapter plates available to use Nissan 4 pots with the forks?

Cheers

[gsx1100e]

I measured my inazuma wheel and gsx e forks I wouldn't  try. Less work to change complete front end.

It would be thinght between fork tube and brake disk there is about 5mm gap, where build adapter for brake caliber. Didn't  check axle diameter for bearings. 

And mayby next commenter tells that it's easy thigh..

[Mak595]

Thanks, sounds like either keep it with standard wheels or go for a full swop then..

Thanks

 

Edit - been checking out the 600 bandit rim is narrower at 3" rather than the 1200 at 3.5

Edited August 1, 2018 by Mak595

[Gammaboy]

3 hours ago, Mak595 said:

Edit - been checking out the 600 bandit rim is narrower at 3" rather than the 1200 at 3.5

Doesn't move the discs any closer together!

[Mak595]

13 hours ago, Gammaboy said:

Doesn't move the discs any closer together!

Ahh so the hub is the same size?

 

Last winter I put a set of 17" wheels in a vmax, I used a 3" rim as it fit where a 3.5 need the inner fork machining down...

[Gammaboy]

As far as I know, yes, the hub is the same width.

[Mak595]

23 hours ago, Gammaboy said:

As far as I know, yes, the hub is the same width.

Thanks