what does epoxying carb slide hole do?

[boilerdude]

I have this factory pro jet kit and it says epoxy one of the holes in each plastic slide. just curious whats that changes.

  

[colinworth79]

Think it changes the rate at which the cv slide will rise when you snap the throttle open . Not 100 % sure if it will slow it down or speed it up .

[boilerdude]

Yea I was wondering which is which... i'll figure it out. 

[Swiss Toni]

Go to the Factory Pro website. All the carb set-up data's there, and a lot more info too!  

[boilerdude]

I cured the stumble I was having... It was not to do with the slides being plugged. That is fine. What happened was I installed the brass float valve thingy's from my bandit carbs. They had 4 cross vents whereas the gsxr750m units had no vents. I thought to myself "I'm sure they're the same thing the newer ones are just a better design" So I installed those brass thingy's out of the bandit carbs. And used a mix match of the needle valve thingy's thinking they're all the same... Well this last time I had them apart. I decided to do some closer examination. The 750m float needles do not match up correctly inside the brass thingy's out of a bandit. Not all mikuni bst parts are as interchangeable as they look at first glance...