carlinmidarlin Posted September 26, 2016 Posted September 26, 2016 Any info on how to remove the oil sight glass on the engine casing so I can have it powder coaded cheers mick Quote
clivegto Posted September 26, 2016 Posted September 26, 2016 just press it out with a press or like I did the last one with a socket and a hammer. Quote
jameskat Posted September 26, 2016 Posted September 26, 2016 Removed as much of the white sealant from the back and then used a piece of acetal, as it was about the right size, and a hammer and then knocked it out from the outside. I thought I was being a bit ham-fisted about it, but it worked for me so no guarantees. Quote
yantosh Posted September 27, 2016 Posted September 27, 2016 cover it with rags , tap it out with a punch of the biggest dia that will fit, Quote
carlinmidarlin Posted September 28, 2016 Author Posted September 28, 2016 (edited) Cheers fellas I'll have a go this weekend Edited September 29, 2016 by carlinmidarlin Spelling Quote
Jaydee Posted September 28, 2016 Posted September 28, 2016 Have a look at this similar thread. http://old-skool-suzuki.proboards.com/thread/5480/oil-site-window 1 Quote
carlinmidarlin Posted September 30, 2016 Author Posted September 30, 2016 Top advice , job done now , I must admit I thought it would break cheers mick 2 Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.