Slingshot wheel into Srad forks

[Blue]

Just bought a set of 750 srad legs to go into 750L yokes & using same calipers, tge wheel spindle is 25mm not 20mm is it a case of just changing tge wheel bearings? Will discs be OK? (Are the caliper brackets on the knuckle in the same position ie not making the caliper higher for bigger discs?)

[Joseph]

Changing bearings is probably an option however you will lose the speedo cable drive. That will be something to take into consideration unless you already have an electronic dashboard.

600 SRAD had 320mm discs for some reason but the USD 750 had 310 so you're good there

Edited April 26, 2022 by Joseph

[Blue]

Many thanks, bearings seem to be 2mm narrower hope that'll be OK. Running a koso speedo 

[TonyGee]

if you change the bearings to 25mm ID the spacer between them will be too small. 

[Joseph]

And forgot another crucial point : disc spacing width and rim hub width needs to be assessed, and also fork tube spacing. Much easier to fit the whole front end i think

[Blue]

My lathe will sort out any change with spacers  width between forks should be the same as I'm using 50/54 in the slingshot yokes  should all line up 

 got 2 weeks holiday in florida to think about it