Jocalopse Posted November 28, 2015 Posted November 28, 2015 (edited) Gentlemen. I am attempting to build a special, it isn't easy here in far Eastern Canada, away from all the bright lights and specialists. So far it's been a stilted project, I'd throw money at it when I could afford it, it's been a two year project so far. What I currently have is a GSX1100ET frame with a B12 swing arm, resprung GSXR750 front end, and now I've bought an 1127 oil boiler engine for it. Apparently it has a big bore kit, but until I can track down the builder I won't believe it. What I need is engine mounting plates for an 1127CC engine into an ET frame, can anyone help? Edited November 28, 2015 by Jocalopse Quote
Captain Chaos Posted November 28, 2015 Posted November 28, 2015 Hi and welcome.Check this out. 2 Quote
Jocalopse Posted November 29, 2015 Author Posted November 29, 2015 anyone have them in a size that's legible? when I enlarged it the numbers weren't clear enough to make out Quote
Gixer1460 Posted November 29, 2015 Posted November 29, 2015 anyone have them in a size that's legible? when I enlarged it the numbers weren't clear enough to make out Whats wrong with the 'GSX Laser' drawings below? Click on them and they open fine for me? Quote
Captain Chaos Posted November 29, 2015 Posted November 29, 2015 Whats wrong with the 'GSX Laser' drawings below? Click on them and they open fine for me?they are for the EFE frame.Somehow the smaller ones should also open but they don't. Quote
Jocalopse Posted November 30, 2015 Author Posted November 30, 2015 I was hoping to get away with no welding, I had seen the plates on the old site, but didn't save them. Idealy I'd just hand over the specs to a shop and have them cut them out, then bolt it all up. damn near done, just have to fiddle with the chain run next and wiring. This engine sounds good, just need to do the transplant. 1 Quote
Jonboy Posted December 1, 2015 Posted December 1, 2015 (edited) I was hoping to get away with no welding, I had seen the plates on the old site, but didn't save them. Idealy I'd just hand over the specs to a shop and have them cut them out, then bolt it all up. damn near done, just have to fiddle with the chain run next and wiring. This engine sounds good, just need to do the transpla Warp Speed Racing used to have a set in their catalogue, might be worth giving them a ringhttp://www.warpspeedracing.co.uk/?attachment_id=139 Edited December 1, 2015 by Jonboy added link Quote
Quist Posted December 1, 2015 Posted December 1, 2015 Don't know if I may post it in here.But I have 7 sets left of 10, lasercut out of stainless steel coming in this week. (same set as Warpspeed)The first testfit set out of wood (upper back one is missing in the picture)First set (normal steel), which is on my dragbike right now. 1 Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.