wraith Posted July 29, 2020 Share Posted July 29, 2020 Just need to check with you lot, finding it hard/impossible to get neutral when engine is running. All the other gears go in nice and smooth with no problems. I've re-blead the clutch, cleaned the push rod and checked the the outer basket and inner basket/hub have not got big groves in them. So now down to ever selector rod or selector forks? Is there anything else I need to look at? Cheers for any help. Quote Link to comment
Askamaskinservice Posted July 29, 2020 Share Posted July 29, 2020 What oil you got? Quote Link to comment
Nik Posted July 30, 2020 Share Posted July 30, 2020 (edited) Warped steel plates? Edited July 30, 2020 by Nik Quote Link to comment
clivegto Posted July 30, 2020 Share Posted July 30, 2020 Might be the depth of the clutch stack. Measure each fiber plate to see that there within specs, replace any worn, blued or warped steels a little bit on each one will be a lot on the hole stack 1 Quote Link to comment
fatblokeonbandit Posted July 30, 2020 Share Posted July 30, 2020 Easiest thing to do is to fit a slightly longer push rod, being hydraulic it shouldn't make any difference as its self adjusting, but i had similar issue with a power screen motor once. Turned out I had mixed up the rods and the one in it was too short, i put the correct one in and all was well. worth a try. 1 Quote Link to comment
wraith Posted July 30, 2020 Author Share Posted July 30, 2020 FBB, you've got it, was making two stainless rods, one for the F motor and for the little b6 motor, and I put the wrong ones in each motor sometimes asking a questions just makes you think of the obvious you didn't think of 4 Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.