carlinmidarlin

Any info to this please I've got a bandit 1200 engine that's got gsxr pick ups fitted but the gsxr looms shite so could I just plug a bandit 12 loom into it cheers mick

Top advice , job done now , I must admit I thought it would break cheers mick

Cheers fellas I'll have a go this weekend

Any info on how to remove the oil sight glass on the engine casing so I can have it powder coaded cheers mick

How much are they jonny1 pump ?? , have you a item number and how hard to fit to a bandit engine mate cheers Micky

Damm phone , quick shifter

Hi , has anyone done or got a link to fitting a Weill shifter to a slingshot cheers mick

Yeh it idles fine mate but the Rev counter only starts at 3000 so it doesn't show much on choke

Looking at the bike it's all 1200 bandit stuff I'd carbs , Cdi etc , as for running its good apart from the pulling up to a stop , it's just like you have hit the kill switch but hit the starter and it starts again

Hi all , I bought this a couple of months ago but only been out proper today , it's a 750 j but has a 1200 bandit donkey init , when it starts up its always abit fluffy , I went out today and it's a blast until you pull up at a junction or lights then it cuts out 99% of the time , pissin me off now as when you ride it there's no flat spots or anything and pulls really good , any info please before I go stripping carbs cheers mick

I've got a slingshot gsxr with a 1200 bandit motor fitted with loom etc , has anyone any info if later , later better looking gsxr switch gear fit or how hard it is to fit

Here's my J , sadly bought like this not built by me , goes very well

Here's the gsxr 1000 k9 plug on the back of the dash

Here's a couple of pics , I've just picked up a manual so I think the tacko may be right whe I start the cut n shut , is there any way of cuttin into the loom so I can use the gear indicator

I'll get some sorted this afternoon Cheers

Hi , I've got a hm dash for my project , it came of a gsxr 1000 k9 , I have the hm back plate fitted withe the k9 loom ( these are plug n play ) I've also got the wiring diagram but I can't get me head around how to wire it into my bandit loom , im looking for help to get the rpm and gear indicator to work , the speedo works off gps so that ok cheers mick

I've just had 2 new ones done for £13 at my local lock centre

Me to mate

Cheers jaydee I'll look at the 1 I've made cheers mick

Can anyone give us any info on the length of the clutch push rod for a 1200 bandit , I've made 1 up from what I guy told me but it's not opening the clutch fully , have I made it to short or to long cheers mick