davecara Posted May 18, 2017 Share Posted May 18, 2017 I'm getting some of our famous engine mounts laser cut for my EFE but the company doing them will only do a minimum quantity of 3 sets. Anyone in the market for a set? Likely cost will be about £30 but if you want a set let me know and I should have a firm cost tomorrow Quote Link to comment
Captain Chaos Posted May 18, 2017 Share Posted May 18, 2017 depending on where you get the drawings from, carefully check the dimensions. I remember the bottom rear mounts are 10mm too short on the drawings I got from the old site some 10 years ago. Quote Link to comment
davecara Posted May 18, 2017 Author Share Posted May 18, 2017 I've got them from the vault on here this morning Quote Link to comment
Swiss Toni Posted May 18, 2017 Share Posted May 18, 2017 3 hours ago, Captain Chaos said: depending on where you get the drawings from, carefully check the dimensions. I remember the bottom rear mounts are 10mm too short on the drawings I got from the old site some 10 years ago. I thought that was ET/EX to oil boiler, rather than EFE to same that was wrong? Quote Link to comment
Captain Chaos Posted May 19, 2017 Share Posted May 19, 2017 8 hours ago, Swiss Toni said: I thought that was ET/EX to oil boiler, rather than EFE to same that was wrong? no, the EFE mounts were wrong. And possibly still are. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.